Automatic Technology Australia Elite Instruções de Operação descarregar pdf (Página 16)

WIRING TERMINALS & CONNECTORS

LOCK RELEASE OUTPUT FOR SOLENOID LOCKS.

Figure 15 shows how to connect an electric solenoid lock

to the control board’s lock release output. Note the lock release

output only switches the applied voltage to the lock and must be

“wetted” with the appropriate voltage.

ATA Electric impulse lock Order code 90101.

Figure 15: Wiring solenoid locks

CONTROL AND SAFETY INPUT TERMINALS.

Figure 14 shows how to wire the control and safety input

terminals to switches, such as a Photo Electric Beam. Note that

the P.E., OPN and STP inputs require a normally closed contact,

which is provided by the shunts (see Fig 11 and Fig 14).

The appropriate shunt must be removed when the P E, OPN

or STP inputs are used. The CLS, OSC and PED inputs require

a normally open contact.

ATA Photo Electric Beams are available:-

Order code 90214 for receiver/transmitter type.

Order code 91315 for reflective type.

Figure 14: Wiring control and safety inputs.

LOCK RELEASE OUTPUT FOR MAGNETIC LOCKS.

Figure 16 shows how to connect an electromagnetic lock to the

control board’s lock release output. Note the lock release output only

switches the applied voltage to the lock and must be wetted with the

appropriate voltage (24VDC in the example shown).

Note that the lock is connected to the normally closed contact of the

lock release output as the lock is energised when the controller is idle

and not driving the motors. Note the lock output's action will need to

be programmed for a hold action when this type of lock is used.

Figure 16: Wiring magnetic locks

LIGHT CONTROL RELAY MODULE.

Figure 17 shows how to connect the optional relay module to

the

control board’s connector [21]. It also shows how to wire a light

to the relay module. ATA supply this with a 240VAC to

24VDC relay. Any voltage relay can be used provided the relay

module is able to switch the required voltage and current. Make

sure any mains voltage lighting is properly earthed.

E.g., Use this to control lights on a gate pillar, garden lights or

security lights.

ATA order code 90111.

Figure 17: Wiring light control relay module.

Page 16

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

Automatic Technology Australia Elite Instruções de Operação Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Automatic Technology Australia Elite